This page describes how to safely and easily install, turn on and off, and remove your custom toolbar.

Installation of the toolbar is a simple process and it involves these steps:

• Click here to install the 2WheelPerformance Toolbar!
  
  
• You will see a dialog like this:
  
  
  
  
• Select the Open button and run the installation program immediately.
  
  Note: If your browser is set to be very 'secure', it may not allow you to Open the program immediately. If this is the case, simply Save the program to your desktop and run it from there later by double-clicking on the icon.
  
  

• When you Open the toolbar installation program or run it from your desktop, you will be presented with this dialog:
  
  
  
  
• All you need to do now, is click the Install button, and the toolbar will be installed in the default location. If you wish to change the default, you may.
  
  
• The custom toolbar is now installed on your system, and may be activated in your browser.
  
  

• The final step is to add the toolbar to your browser window, and position it where you wish. The first step, is to open up a new Internet Explorer window.
  
  
Your new toolbar is now fully installed and ready to use!

• Once the toolbar is installed, you may wish to turn it off or back on again without removing it from your system. To do this, simply select View Toolbars from Internet Explorer, and then enable or disable the checkmark next to the toolbar you wish to enable or disable as shown here:
  
  
  
  
  Note: After enabling or disabling a toolbar, you may wish to move the positions of the toolbars around. To do this, simply grab the handle (as described above) and position the toolbar where you'd like it.